27
Main menu
Sub menu
Function
System
information
Hard disk information
Display hard disk capability and recording time
Code stream statistics
Display code stream information
Log information
Clear all log information according to the log video and
time
Edition information
Display edition information
Shut down
Logout or reboot
4.2 Record
4.2.1 Record Configuration
To set the recording parameters in the surveillance channel. The system is set
up for 24 hours consecutive recording in the first startup. You can enter [main
menu]> [recording function]> [recording setup] to set.
Note
:There must be at least one read-write hard disk.(refer to chapter 4.5.1)
Picture 4.1 Record Config
(
Channel
) Choose the corresponding channel number to set the channel. Choose
the all option to set every channel to the same.
(
Redundancy
) Choose the redundancy function option to implement the file
double backup function. Double backup is writing the video files to two hard
disks. When you do the double backup, make sure that there are two hard disks
installed. One is read-write disk and the other is redundant disk. (refer to 4.5.1)
(
Length
) Set the time length of each video file. 60 minutes is the default value.
(
PreRecord
) Record 1-30 seconds before the action. (time length is decided by
the code stream)
(
Record mode
) Set the video state: schedule, manual or stop.
Schedule
: Record according to the set video type (common, detection and alarm)
and time section.
Manual
: Click the button and the relevant channel will start recording no matter
what else the channel has been set to do.
Stop
: Click the stop button and the relevant channel stops recording no matter
what else the channel has been set to do.
