© Copyright QVIS® All documentation rights reserved.
44
PPPOE
Enable
：
Reverse ■ means choose, setting can become effective.
Input the user name and password that ISP
（
Internet service provider
）
provides.
After saving it, reboot up your system. Then the DVR will build a network
connection based on the PPPoE. The IP address will change into dynamic IP
address after above operation is well done.
Operation
：
After PPPoE dialing has successfully looked up the IP
address in the [IP address] and obtain the current IP address. Then use
this IP address to visit the DVR through user port.
【
NTP setup
】
NTP
The NTP server must be installed in the PC.
Enable
：
Reverse ■ mean choose
，
setting can become effective.
Host computer IP:
Input the IP address installed NTP server.
Port:
Default: 123. You can set the port according to NTP server.
Time zone:
Update Period:
The same with the NTP server check interval. Default:
10minutes.
【
EMAIL setup
】
If the alarm is triggered or the alarm snapshots are taken, you can setup the DVR
to send an email containing alarm information and the photos to an appointed email
address.
