WWW.DUALSIG.COM
31
Picture 4.6 set the time section
(
Interval
) Only one alarm signal is turned on even if there are several motion
detection signals in the set interval.
(
Alarm output
) Starts the external equipment of the linked alarm when the motion
detect alarm is turned on.
(
Delay
) Delay a few moments and stop when the alarm state is turned off. The
range is 10~300 seconds.
(
Record channel
) Choose the recording channel (multiple options are supported).
Trigger the video signal when the alarm is turned on.
Note
: Set in the [recording setup] and perform the linked recording. Start detecting
video iles in the corresponding time section.
(
Tour
)
means that the selected channel is a single window alternate patrol
preview. The interval is set in the [MainMenu]>[System] > [Tour].
(
Snapshot
) Choose record channels, when the alarm activates, the system
triggers the related channels for a snapshot signal.
Note
: For snapshot activation, please go to set period, detect and alarm enable at
MainMenu->Record->Record conig,
(
PTZ Activation
) Set the PTZ activation when the alarm is turned on.
Note
: PTZ activation is set in the [shortcut menu] >[ PTZ control]. Set the patrol
between spots, trail patrol and so on.
Picture 4.8 PTZ Activation
(
Delay
) When alarm is over, recording will last a few seconds(10~300sec),then
stop.
(
Show message
) Pops the alarm information dialog box into the local host
computer screen.
(
Send EMAIL
) means sending an email to the user when the alarm is turned on.
Note
: Set in the [NetService] and send email.
WWW.DUALSIG.COM
