WWW.DUALSIG.COM
52
5).
Real-time image problems such as the image color or the brightness
distortion.
Possible reasons are as followed:
1 When using the BNC output, the option between the N mode or PAL
mode is wrong and the image becomes black and white.
2 The DVR is not matched the monitor impedance.
3 The video transmission distance is too far or the loss of the video trans
mission line is too large.
4 The color and brightness setting of the DVR is wrong.
6).
I can not ind the video iles in local playback mode.
Possible reasons are as followed:
1 The data line of the hard disk is damaged.
2 The hard disk is damaged.
3 Update the different program with the origin program iles.
4 The video iles to look up are covered.
5 The recording is not on.
7).
The local video is not clear.
Possible reasons are as followed:
1 The image quality is too bad.
2 The reading program is wrong. Reboot up the DVR.
3 The data line of the hard disk is damaged.
4 The hard disk is damaged.
5 The hardware of the DVR is damaged.
8).
There is no audio signal in the surveillance window.
Possible reasons are as followed:
1 It is not an active tone arm.
2 It is not an active sound box.
3 The audio lines are damaged.
4 The hardware of the DVR is damaged.
9).
There is audio signal in the surveillance window but no audio signal
in the playback state.
Possible reasons are as followed:
1 Setting issues: the audio option is not chosen.
2 The according channel is not connected with the video.
10).
The time is wrong.
Possible reasons are as followed:
1 Setting is wrong..
2 The battery is in bad connection or the voltage is too low.
3 The oscillation is damaged.
WWW.DUALSIG.COM
