44
FCC, ACTA and IC Regulations
FCC, ACTA and IC Regulations
FCC, ACTA and IC Regulations
FCC, ACTA and IC Regulations
FCC, ACTA and IC Regulations
This equipment complies with Parts 15 of the Federal Communications
Commission (FCC) rules for the United States. It also complies with regula-
tions RSS210 and CS-03 of Industry and Science Canada. Operation is subject
to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
A label is located on the underside of the Base Unit containing either the
FCC registration number and Ringer Equivalence Number (REN) or the
IC registration number and Load Number. You must, upon request, pro-
vide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact
the Supplier:
at (800) 651-6791.
at (800) 651-6791.
at (800) 651-6791.
at (800) 651-6791.
at (800) 651-6791.
For repair/warranty information. The telephone company may ask you to dis-
connect this equipment from the line network until the problem has been
corrected.
FCC Part 15
FCC Part 15
FCC Part 15
FCC Part 15
FCC Part 15
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
The equipment has been tested and found to comply with part 15 of the FCC
rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try and correct the interfer-
ence by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet or on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Additional InformationAdditional InformationAdditional InformationAdditional InformationAdditional Information
Summary of Contents for 20-2432
Page 50: ...91 5598 10 00 ISSUE0...