Door and Glass Information FDV451 / MQFDV453
Glass Cleaning
It will be necessary to clean the glass periodically. During startup, condensation, which is normal, forms on the inside of
the glass, and causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It is therefore recommended that initially the glass be
cleaned two or three times with a fireplace glass cleaner. After that, the glass should be cleaned two or three times a
season depending on the circumstances.
Glass Replacement
Only Robax ceramic or coated Neoceram glass may be used for replacement for all FDV451 / MQFDV453 Models. Glass
must be minimum 5mm thick.
To replace glass, clean all materials from the door frame. Scrape off old silicone all the way down to the metal. Using
high-
temp silicone [rated up to 500°F (260°C)] apply a continuous bead of approximately 1/8”-3/16” to all four [4] sides of
the frame. With the frame resting on a flat surface, insert the new glass with a new gasket. Gently press the glass into the
silicone. Be careful not to use excessive force on the glass. Let the silicone dry for approximately 15-20minutes.
Use caution when removing broken glass. Wear gloves.
Removal of the Glass Front Door
1. Remove the door by unlatching the 2 top latches. Simply place 2 fingers in the grooves, and pull and lift upward
slightly.
2. Once the top of the door is unlatched, pull it outward and lower it to unlatch the bottom.
3. To re-install, place the Bottom Door Ledge into the 2 Lower Latch assemblies first. Then swing the door closed to seal
it against the firebox cavity. Re-latch the Upper Latch assembly to secure the door to the appliance.
Removal of the Glass Side Doors
1.
Remove nuts with a 7/16” wrench.
2. Remove Door.
Spring Replacement
*Over time, the door latch spring (Part#36HB-123) may need to be replaced if tension is lost.
1. To replace latch spring, remove the 2 hex screws (located in the firebox) that secure the latch assembly in place.
2. Once the screws are removed the latches will slide out of place.
3. Remove the locknut from the latch assembly and replace the spring. Re-tighten the locknut until 2 thread turns are
beyond the locknut. This is critical for proper tension. Replace latch assembly.
⚠
Cautions and Warnings
Do not clean when the glass is hot.
The use of substitute glass will void all product warranties (see
Glass Replacement
in this section).
Care must be taken to avoid breakage of the glass.
Do not operate this fireplace without the glass front or with a broken glass front.
Do not strike or abuse the glass.
13
Summary of Contents for Kingsman FDV451N
