Pa
ge
7
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
Note:
Before a final installation, we recommend a test-run to ensure the compatibility of the
vehicle and the interface.
Due to changes in the production of the vehicle manufacturer there’s always a possibility of
incompatibility.
2.1.
Place of installation
The interface is built to be connected at the factory monitor.
