Version 06.03.2020
HW CAM(V31),(V22)
RL2-MMI3G-Q3/GW
S
e
ite
10
Note: Check the LEDs on CAN-box after reconnecting the battery, two must be on.
Not all vehicles are kompatible. If the CAN-box does not deliver ACC to pin2 of the video-
interface or blocks the thevehicle’s CAN, it is possible to install the video interface without
the CAN-box (analog). In this case see also note in chapter “After-market rear-view
camera”. For analogue connection see 6pin assignment above.
2.4.
Connection – head unit
Remove the
grey
(Depending on the head-unit, possibly also white or
pink
coloured!)
female 4pin HSD connector from the rearside of the factory head unit and connect it
to the aubergine colored male 4pin HSD connector of the picture signal cable.
Connect the
waterblue
colored female 4pin HSD connector of the picture signal cable
to the previously become free
grey
(Depending on the head-unit, possibly also white
or
pink
coloured!) male 4pin HSD connector of the factory head-unit.
Connect the
waterblue
colored female HSD+2 connector of the picture signal cable
to the male HSD+2 connector of the video-interface.
Note: No liability for vehicle wire colours and pin definition!
Changes by the vehicle manufacturer are possible. The given information has to be verified
by the installer.
