Version 11.09.2020
HW: CAM(V100)/(V52)
RL4-NAC
P
a
g
e
9
1.7.
Settings of the 4 Dip switches (CAN function - red)
Dip position down is
ON
and position up is
OFF
.
Navigation / Sy5tem
Dip 1
Dip 2
Dip 3
Dip 4
NAC infotainments
OFF
OFF
OFF
OFF
Set all 4 dips to OFF.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
2.
Installation
Switch off the ignition and disconnect the vehicle’s battery! The interface needs a
permanent 12V source. If -according to factory rules- a disconnection of the battery has to
be avoided, it should be sufficient to use the vehicle’s sleep
-mode. In case, the sleep-mode
doesn’t succeed, the battery has to be disconnected with a resistor lead.
The Interface needs a permanent power supply! If power isn’t directly taken from the
battery, the connection’s power has to be checked for being start
-up proven and
permanent.
Before the final installation, we recommend a test-run of the interface. Due to changes in
the production of the vehicle manufacturer, there’s always the possibility of
incompatibility.
2.1.
Place of installation
–
video-interface
The video-interface is performed to be installed at
the head unit’s rear side.
Erfahrungswerte zu Einbauorten:
Radio/Navi in
Peugeot 2008 FY 2019
vehicles: Directly behind the display.
Head Units in
Peugeot 5008
and Opel
Grandland X
vehicles: Behind the centre console (for
this, remove the panel in the passenger footwell).
