www.rm-suttner.com
Page 3, Vers. 2019-06
Warning
Disconnect the surface cleaner from a pressure washer and ensure that the washer is not pressurized
before performing any inspections, maintenance or adjustments to avoid any wildly spraying fluid that
can easily cause personal injury and property damage.
Maintenance
Cleaning and maintenance
Please do not clean this device by means of high pressure jets. Please use a customary cleaning
agent.
When putting down the surface cleaner please take care that the splash guard is not deformed by
unevenness.
Assembly
1. Please screw the nozzles (nozzles 1/4
“
M NPT are required) into
the rotating arm. Please plug your spray gun into the connection
and screw it tight.
2. The high pressure cleaner can now be connected and the device
is then ready for operation.
Troubleshooting
Please check the list below before addressing the problems to servicing personnel including the local
dealer. If the problem continues after the following troubleshooting, please call your local dealer for
future assistance.
fig 1
Nozzle blocked (not
spraying)
Dirty nozzle
Twist the nozzle off and
clean by needle, tip
cleaner or paperclip
Spray outward from
rubber lip
Damaged rubber lip
Replace the rubber lip
Caster won’t roll or
swivel
Dirt in caster
Clean the caster
(fig 1)
User Manual of turbodevil
floor cleaner series
turbodevil
floor cleaner (BASIC / INDUSTRIAL)
Article no.: 521 030 300 / 521 042 300 / 521 052 300-304 / 521 042 400 /
521 052 400 / 521 052 900 / 521 075 300-304 / 521 042 350 / 521 042 450 /
521 042 500
R+M / Suttner recommendation:
tip cleaner
R+M Nr.
diameter
200 049 042
0.5
High speed steel (HSS)
with aluminium shaft.
Length 42 mm
