D
4.
Slide brush
"E"
in onto brush driver on opposite side and
spin until you feel it catch and drop in.
(SEE BELOW)
5.
When the brushes are engaged, replace the brush
access door.
6. Lift up on the wipers first to close the side door and
depress the latch until the door is secured.
NOTE:
If the brushes are not fully engaged with the
drivers the brushes will be damaged.
Do not force the access door back on.
This usually indicates improper brush installation.
E
PAGE 12
INSTALLING CYLINDRICAL BRUSHES
1. Turn on machine power.
2. Raise the scrub deck by depressing the brush
switch (O) to the up and off position and turn
machine power back off.
3
.
Disconnect batteries.
3. Remove side access door
"D"
on each side of
scubdeck.
(SEE BELOW)
7.
Brush driver shown misaligned.
(SEE BELOW)
8.
Brush driver shown properly aligned.
(SEE BELOW)
9. To adjust the tension of the belts turn
adjustment screw
"F"
clock-wise to tighten,
counter-clockwise to loosen.
(SEE BELOW)
10. To adjust the height of the wipers loosen
the 3 screws
"G"
and slide wiper blades up
or down in the slots.
(SEE BELOW)
F
G
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
