PAGE 16
DRAINING SOLUTION TANK
To drain unwanted cleaning solution from the solution tank,
perform the following steps.
(SEE BELOW)
1. Pull the clear sight tube/drain hose
"A"
off barbed fitting.
2. Rinse out tank and solution flow system with clean water.
ADJUST SOLUTION FLOW
1. Turn solution valve adjustment knob
"A"
counter-
clockwise to increase solution flow,
clockwise to decrease solution flow.
(SEE BELOW)
DRAINING RECOVERY TANK
Always empty recovery tank when refilling the solution tank.
You can refill the solution tank while the recovery tank is draining.
To drain the recovery tank, remove drain hose from hook at rear
of tank and unscrew cap.
(SEE BELOW)
NOTE: LEAVE RECOVERY LID OPEN WHEN DRAINING TANK!
A
A
B
A
B
ADJUST CURTAINS/WIPERS
1. For Jaw curtains release latch
"A"
and remove pin
"B"
on front of jaws to open jaws.
(SEE BELOW.)
2. Loosen curtain band screws
"
C"
.
3. To adjust curtain to the desired height just slide the
curtain up or down in the slots and tighten screws.
4. Close jaws, reconnect latch and reinsert pin.
C
1. For cylindrical side wipers loosen wiper band screws
"D"
.
(SEE BELOW)
2. To adjust wiper to the desired height just slide the
wiper up or down in the slots and tighten screws.
D
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
