_______________________________________________________TCA 9000 Series User Manual
2
Operating Environment
Your TCA Autoloader system should be used in a climate controlled
environment free of dirt, dust, excess humidity, excessive heat or electro-
magnetic interference. Your TCA Autoloader system should be placed on a
sturdy level surface – away from sources of vibration.
Allow at least four (4) inches, (10cm), of clearance around the sides and back
of the unit for ventilation.
Power On
After the power is turned on the TCA Autoloader goes through a series of self-
tests. If the Main Menu prompt does not appear within a minute or so see the
Error Messages section of this manual.
Quick Start Copying
This quick start section assumes the Duplication Options
(Setup Menu |
Duplication Options)
are set as shipped from the factory. If they are not or if these
instructions do not work then go to the Operation chapter of this manual for
detailed operating instructions.
Place one Blank disc onto the Input stack (the left spindle).
Use the up
/\
or down
\/
arrow keys to put the
>
cursor (on the Left of the LCD
display) next to the
Start Copying
menu line. Press the
ENTER
key to select that
menu function. If there is already an image on the hard drive the following
prompt will be displayed:
Read New Master?
Press the YES key. The next prompt will be for an Image name (this will be
the first prompt if there are no images on the hard disk).
Enter Image Name
[
]
To use the default name just press the ENTER key at this point (see the
Entering Text section of the Operation chapter for instructions on entering an
image name). Next the system will ask for the number of copies to record:
Enter Quantity
[
]
Press the up arrow key
/\
to set the quantity to
[0001].
Then press the
ENTER
key to accept the quantity. The top drive tray will open and the following
prompt will be displayed:
