5
Safety Precautions
Read entire section before starting installation
WARNING!
Electric Shock can kill. Only qualified personnel should perform this installation. Turn off input power at the fuse box
before working on this equipment. Do not touch electrically live parts. Always connect the machine to an earthed
mains supply as per national recommended standards.
Select suitable location
Place the plasma cutter where clean cooling air can freely circulate in and out of the front & rear louver vents. Dirt, dust or
any foreign material that can be drawn through vents into plasma cutter must be kept to a minimum. Failure to observe
these precautions can result in excessive operating temperatures which can lead to plant failure.
Grinding
Do not direct grinding particles towards the plasma cutter. An abundance of conductive material can cause plant failure.
Transport Unloading
Never underestimate the weight of equipment, never move or leave suspended in the air above people. Use
recommended lifting equipment at all times.
WARNING!
Falling Equipment can cause injury. Never lift plasma cutter with gas bottle attached. Never lift above personnel.
Tilting
Machine must be placed on a secure level surface or on a recommended undercarriage/trolley. This machine may topple
over if this procedure is not followed.
Environmental Rating
The plasma power source carries the IP21S rating. It may be used in normal industrial and commercial environments.
Avoid using in areas where water / rain is around.
