17
Burnback control
Burnback is how long the welding power will continue after wire feed has stopped, this stops the wire
from sticking to workpiece when weld finished, if Burnback is set too long you can experience wire burning
back to tip.
You can adjust Burnback by pressing left or right arrow buttons until Burnback is flashing, then use left
knob to adjust from 0s to 2.0s
For most applications a setting of 0.3s is advised.
Spool on Gun option
For best results when welding aluminium we recommended using a spool on gun as shown in image below
You can select spool gun function by pressing left or right arrow buttons until SPOOL is flashing, then use
left knob to switch from off/on. When switched on the internal wire feed is disabled.
Disconnect standard MIG torch and connect spool gun to euro connector and 7 pin plug to machine
Note: Pure argon is required when welding aluminium.
