9
the HF – Sometimes required when using CNC automated machinery - Not normally used
6.
Air regulator water drain thumb screw
If regulator fills with water, unscrew this thumbscrew slowly to drain of water, screw back tight
once drained.
7.
Air pressure input
Screw supplied PCL fitting into regulator ensuring no air leaks.
You can also fit other connectors to suit your needs
Front machine connections
Fig 2
1.
Earth / Workpiece connector
Connect the earth lead (negative - ) to this connector.
Insert male connector into socket and twist clockwise until tight.
Secure other end of earth lead to Workpiece via the earth clamp.
2.
Torch switch socket
Connect the torch switch plug (4 pin) and screw on retaining ring to secure
3.
Torch power connector
Connect the main torch cable by screw clockwise until tight.
