21
DC EASY MODE
6 easy steps are required to setup weld.
Press left / right arrows to select setting which will be highlighted in red circle and description shown in
bottom of screen. Then use control knob to select value required.
In image below you can see TUNSGTEN SIZE is shown at bottom of screen and circle is highlighted in RED
and showing 2.4mm size selected.
MATERIAL THICKNESS
Then use control knob to select work thickness required.
1.0mm, 1.2mm, 1.5mm, 2.0mm, 3.0mm, 4.0mm
Once correct thickness has been selected, press right arrow to move to next setting.
Once correct tungsten size has been selected, press right arrow to move to next setting.
