23
PULSE SETTING
This is where you select pulse off, or settings as below by turning control knob
Pulse welding was designed mainly for stainless steel and other exotic materials to control heat input to
the metal and decrease heat deformation.
Base amps is set to 75% in DC EASY mode for mild steel.
Base amps is set to 65% in DC EASY mode for stainless steel.
I.E if main amps is 80A, then base amps will be 60A.
At 0.5Hz the machine will switch between main amps selected and base amps every half a second.
At 50Hz the machine will switch between main and base amps 50 times a second.
Pulse can also be useful if you are unable to use a foot pedal and want to have more control over heat
input into weld if not welding at bench.
Pulse speed is a personal preference
-
as the pulse Hz increases you will notice the weld
noise is more higher pitched, this is normal.
Once the desired pulse level has been selected, press right arrow to move to next setting.