R-Tech TIG315, Operation Instructions Manual

7

Make sure fuse or circuit breaker is correct rating for machine. Using fuses or circuit breakers 
smaller than recommended will result in ‘nuisance’ shut off from welder inrush currents even if 
welding at low amperages. 
 
Failure to follow these instructions can cause immediate failure within the welder and void 
machines warranty. 
 

Turn the input power OFF at the mains switch & fuse box before working on this equipment. 
 
Have a qualified electrician install & service this equipment. 
 
Allow machine to sit for 5 minutes minimum to allow the power capacitors to discharge before 
working inside this equipment. Do not touch electrically live parts 
 
The TIG315 Inverter Tig Welder requires a 415V 50/60Hz 3-Phase supply. It requires a 16A supply. 
It comes with a 3 metre mains cable attached. 
 
Connect wires according to national coding. 
 
Brown wire – Live 
Blue wire – Neutral 
Green/Yellow Wire – Earth (Ground) 

Connecting to a mains electrical supply 

THIS MACHINE IS OF AN INDUSTRIAL SPECIFICATION AND MUST BE 

FITTED TO A 16AMP 415V MAINS INPUT  

Connecting to an Engine Driven Generator

If connecting this machine to an engine driven generator please ensure the 

following 

Minimum Generator KVA Output – 15 KVA continuous 

Generator to be fitted with AVR (automatic voltage regulation) 

DO NOT USE ON A GENERATOR WITHOUT AVR 

Connecting to a generator without the above minimum requirements will in-

validate your warranty.