RSP-APE-030M
User’s Manual
R-tron., Inc. 11/15 page
5.2 Preliminary Steps for GUI Execution & Maintenance
5.2.1 Preliminary Steps before using GUI
a. Check all connection status during the installation.
b. Set the baud rate which you are going to use.
c. Connect the repeater main power cable.
d. Connect RSP-APE-030M “LOCAL OMT” with PC, using RS232 cable.
Figure 5.2 Connection RSP-APE-030M with PC
5.2.2 Executing USB Driver & GUI program
a. Excuting “PreInstaller” and check the USB driver is normal and the port number.
Figure 5.3 USB Driver files
b. Excuting “MINI30_USPCS”
Figure 5.4 GUI files
5.2.3 GUI Communication
When the communication between Personal Computer and Repeater MCU board is OK, Tx/Rx yellow
LED which is up-left corner in the GUI screen will be flashed.
Figure 5.5 Communication Verification LED
