10 / 32
User Manual
Rev. 1.0 - 15/12/06
PJ500C-LCD & PJ1000-LIGHT
Open the
Power setup menu
(figure 5.2 - menu 2) pressing the following keys
in the order:
ESC
(opens
Default Menu
)
⇒
ENTER
(hold down for 2 seconds)
Use
SET
menu and
keys to set the desired amplifier output power; the SET
bar at the side provides a graphic display of set power, whereas the forward power
value shown on the display (
Fwd: xxxx W
) gives actual output power reading,
and may be lower than set power if an Automatic Gain Control is in limited-
power mode
(
please read section 5.3 concerning RF power modulation for more
details”
.
Note :
Output power can also be set in a
Pwr OFF
condition; in this condition,
(
Fwd
) output power reading on the display will be 0 (zero), whereas the
SET
bar,
which you can control using the keys, provides a graphic display of the amount of
power that will be delivered the moment you switch back to
Pwr ON
state.
5.2.7 Changing the Power Good alarm threshold
Change Forward Power Good alarm setting
PgD
from the
Fnc
menu as required
(factory setting is 50%).
Please read section 5.3.1 for more details.
5.2.8 Changing machine I
2
C address
Change the
IIC
address in the
Mix
menu as required (factory setting is 01).
Please read section 5.3.5 for more details.
5.2.9 How to enable Remote mode
If you wish to use the telemetry control feature, enable Remote control in the
Fnc
menu (see section 5.3.1 for details).
Note :
In the
Remote
mode, all local push-button controls except
Remote/Local
(for switching back to Local mode) are disabled . Operating parameter readings
are available.
