R.V.R. Elettronica TEX1703, User Manual

8

/ 36

User Manual

Rev. 1.0 - 27/05/21

TEX1703TFT

  5.  Installation and Configuration Procedure

Instructions  are  given  in  this  chapter  on  installation  and  configuration  of  the 

equipment. Carefully perform all the steps described in this chapter both upon 

initial start-up and every time the main configuration is changed, for example when 

moving to a new transmission station or when replacing the equipment.

IMPORTANT:

always disconnect the mains power before carrying out any type 

of installation and/or maintenance. It is imperative to cut off the power supply to 

avoid electric shock hazards that could cause damage to property and physical 

harm, serious injuries or even death.

The equipment must only be installed by qualified personnel.

Qualified personnel are personnel who comply with all the safety directives, laws 

and standards that apply to the installation and operation of this device.

The choice of qualified and duly trained personnel is always the responsibility of 

the employer, since the employer is always the one in the best position to judge 

whether a worker is suitable for a particular job and therefore capable of ensuring 

their safety while respecting the applicable law on occupational safety.

Employers must provide their personnel with adequate training in electrical devices, 

and ensure that they are familiar with the content of this manual.

Compliance with the safety instructions set out in this manual or with the legislation 

indicated does not relieve the personnel from the duty to also comply with other 

specific standards relating to the installation, place, country or other circumstances 

concerning the equipment.

IMPORTANT:

there is a danger of possible electric shocks and it is therefore 

mandatory to comply with the applicable safety law regarding electrical aspects.

Once  configured,  the  equipment  is  ready  for  normal  operation  and  no  further 

intervention is required since all the parameters are saved automatically for when 

the equipment is switched off and on again either intentionally or unintentionally.

The performance and functions of the hardware and firmware of the equipment 

are described in more detail in the following chapters: please refer to the relevant 

sections of the manual for further information on what is covered in this chapter.

IMPORTANT:

during all phases of configuration and testing of the transmitter of 

which this equipment forms part, always keep to hand the test table (“Final Test 

Table”) accompanying the equipment: this document covers all the operating 

parameters of the equipment set and checked at the time of testing after production.