TOUCH30S
12 / 34
User Manual
Rev. 2.1 - 11/06/03
6.1.2 Power supply requirements and setting
Inserire la spina di alimentazione nella presa VDE presente nel pannello posteriore.
Insert the mains plug in the VDE place in the rear panel.
The power supply can work at any voltage between 95 and 130 Vac or between
195 and 265 Vac. A label on the rear, glued close to the ON/OFF switch, indicates
the preset voltage range. If you want to change this voltage, or for fuse replacement,
follow next instructions:
•
SWITCH-OFF AND DISCONNECT from mains the equipment
•
Open the transmitter (see standard "demounting" instructions)
•
Unscrew the cover of the power supply (please control if the plug of input
power cord is out of its receptacle!!), see photo:
!
"
#
SCREWS
$
%
•
Slide out the internal black plastic cover of the mains socket and change the
two fuses.
• Replace the fuses by using two 1.25 A fuses for 220/230 V range and 2.5 A for
110/117 V. Insert the plastic cover.
• Move the jumper in the position "A" for 110V and “B” for 220V:
&'
&'
A B
• Place the supply cover in the original position and fix the screws.
•
Close the transmitter with the top cover.
Summary of Contents for TOUCH30S
