无锡人人行拍网络科技有限公司
5
4. Port definition
4.1 port
4.1.1Bottom side port
Figure 4.2.1.1 schematic diagram of bottom side port
[1]: BIND button, For bind transmitter and receiver.
Press the button more than 5 seconds, 4 lights (WORK, LINK, HDMI, MOBILE) are all turn-off,
then stop press the button, 4 lights flash one by one, when the LED light works well that means
they are well binded. This may take 2 minutes. If the connection has not been resumed after 2
minutes, repower on both ends, and do not need to rebind.
[2]: POWER button, For turn on/off the power supply.
[3]: WORK light, For monitor the receiver operating status.
Light status
Description
Operation
Flash regularly
Receiver works well
NA
Other status
Receiver does not work well
Connect the power again or
contact with the customer
service
[4]: LINK light, For monitor Transmitter and receiver connect status.
Light status
Description
Operation
Turn-on
Connect with Transmitter
NA
Turn-off
Does
not
connect
with
Transmitter
1. Please wait for connecting
2. Make sure the Transmitter
is connecting the power.
3. Bind the Transmitter and
receiver again.
4. Connect the power again
[5]: HDMI light, For monitor the display device status.
Light status
Description
Operation
Turn-on
Display device connect well
NA
Turn-off
Display device does not
connect
Check Display device cable
position.