4. Accidentally added devices can be deleted by hovering over the device and clicking
the trash bin twice. The trash bin will turn red after the first click. Same applies to
deleting subnetworks and networks.
5. The configuration for the different networks can be changed by clicking on the gear
icon next to the name. All configurable parameters are defined as follows:
A
B
C
D
E
F
A
Optimize For: The configuration can be optimized for reliability, packet length or
latency, or optimization can be disabled by choosing Exact Config.
• Reliability: In this setting, the Reliability parameter is treated as the lower
bound and it is used to select the highest reliability setting suitable for the
input parameters.
• Packet Length: In this setting, the Packet Length parameter is treated as the
lower bound and it is used to select the maximum Packet Length for the input
parameters.
• Latency: In this setting, the Latency input parameter is ignored and the
minimum latency suitable for the other input parameters is selected.
• Exact Config: In this setting, all input parameters are set as specified if the
input parameters provide a valid configuration.
Page 19 of 45
5. Using the Device
