2 x
2 x
B
A
C
A
D
B
G
B
TRANSPORT
FITTINGS ON THE
COMBI FRAME
Placing the Combi Frame in the vehicle:
1. By use of a 4-point strap system, the frame
is secured in the vehicle. (Follow instructions
from the manufacturer of the vehicle).
A 4-point strap-system, approved accor-
ding to ISO 10542-2 or SAEJ2249, must
be used.
On the rear of the frame, fitting A:
2. * Remove the plugs.
* Place the fittings (A) on the rear bar.
* Mount with the enclosed 6 mm long bolts
and nuts. (Note the placement for the different
sizes.)
On the front of the frame, fitting B:
3. * Remove the plugs (D) in the side rails.
* Slide the thread block into the side rails.
* Mount the plugs (D) again.
* Place the fitting (B) over the thread block.
* Tighten with the enclosed 6 mm. bolts and
washer through the holes in the thread block.
It is important that the 'legs' on the fitting (B)
is placed in the holes in the side rails.
The fitting (B) can be turned upwards (as on
the drawing) or downwards if you wish.
4. The wheelchair is fastened in the vehicle by
use of a 4-point strap-system. Either a hook
or a strap can be used for fastening the fittings
(A) and (B).
Stick the enclosed stickers (C) on the four fittings
(A) and (B).
GB
Size 1+2
Size 3+4
29
