FFLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. For fixtures weighing more than 10 lbs - Do not mount to an outlet cover unless a separate splice box is used.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
ARM MOUNTING
1.
Seal arm thread using teflon tape or silicone sealant.
2.
Secure the LED Flood to a 1/2” NPS hole in a junction box
or landscape post. Heavy duty XC1 cover provided.
3.
Plug all unused holes and seal threads with silicone.
4.
The swivel arm on the LED Flood allows 180º of vertical
aiming adjustment depending on mounting location.
SLIPFITTER MOUNTING
1.
The slipfitter mounting fits a 2 3/8” O.D.
Tenon
. Place the
slipfitter over the
Tenon
and secure the fixture with the
two
Set Screws
on the side of the slipfitter.
2.
Remove two screws and plug on side of
Round Cover
Plate
. Remove the
Round Cover Plate
and adjust the
angle of the fixture.
3.
Loosen the
Locking Bolt
and swivel fixture to desired
angle.
4.
Tighten the
Locking Bolt
and re-attach
Round Cover
Plate
.
TRUNNION MOUNTING
CAUTION
:
UL and C-UL listed or CSA certified liquid tight
cord grip suitable for use with three conductor type
STW flexible cord shall be used for connection to a wet
location outlet box provided by others
.
To adjust the angle of the fixture using the trunnion:
1.
Loosen the Pivot Bolts & angle locking screw.
2.
Adjust fixture to desired angle.
3.
Tighten
Pivot Bolts
& angle locking screw.
Locking
Bolt
Tenon
Set Screws
Round
Cover
Plate
Pivot Bolts
FFLED Arm
FFLED Trunnion
FFLED Slipfitter
CLEANING & MAINTENANCE
CAUTION: Be sure fixture temperature is cool enough
to touch. Do not clean or maintain while fixture is
energized.
1.
Clean glass lens with non-abrasive glass cleaning
solution.
2.
Do not open the fixture to clean the LED. Do not touch
the LED.
TROUBLESHOOTING
1. Check that the line voltage at the fixture is correct. Refer
to wiring directions.
2. Is the fixture grounded properly?
3. Is the photocell, if used, functioning properly?
