RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
INSTRUCTIONS
HALV Indoor Architectural-Grade LED Wall Sconce
CLEANING AND MAINTENANCE
TROUBLESHOOTING
1. Use warm water, mild soap and a soft sponge or cloth. Any
acrylic cleaner may also be used. Do not use alcohol, glass
cleaners, acetone, lacquer thinner, solvents or abrasive
compounds. Do not use squeegees, scrapers or synthetic rags
that may scratch the panels.
a. Lumicor® lenses – Novus® cleaner and polish is an
approved product for a clean shine that also protects from
static build up. See the “General Polishing & Basic Scratch
Repair” document at www.lumicor.com/ScratchRepair for
more information.
2.
DO NOT OPEN THE FIXTURE TO CLEAN THE LEDs. DO NOT
TOUCH THE LEDs
.
1. Check that the line voltage at the fixture is correct. Refer to
wiring directions.
2. Be sure the fixture is grounded properly.
1. Align
Lens Frame
over the
Driver/LED assembly
with the
phillips head
mounting screw
at the top. See
Figure 5
.
2. Inset the lens frame from the bottom with the bottom flush
against the wall. See
Figure 5
.
3. Tilt the top of the lens frame to the wall.
4. Make sure the frame is flush against the wall and tighten
mounting screw at the top using a 5/64” hex key.
LENS FRAME INSTALLATION
Driver / LED Assembly
DO NOT TOUCH LEDs
Mounting Screw
Lens Frame
FIG.5
Note:
These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation, operation or maintenance.
1. Hang
Driver/LED/Wall plate
assembly on
Hanger Bracket
as
shown in
Figure 4
.
2. Make wire connections.
3. Remove
Hanger Bracket
and place in bottom of box for future
use.
4. Install Driver/LED/Wall plate and tighten 4 phillips head screws.
1. Hang
Driver/LED/Wall plate
assembly on
Hanger
as shown in
Figure 4
Energize fixture. Mate battery connection.
2.
Mate connectors, except for battery connection. Make wiring
connections.
3.
Energize fixture. Mate battery connection.
4. Remove
Hanging Bracket
and place in bottom of box for future
use.
5. Install Driver/LED/Wall plate and tighten 4 phillips head screws.
DRIVER/LED/WALL PLATE/ASSEMBLY
(with E2, E2/MVS, E2/BL, or LC/E2 Options)
DRIVER/LED/WALL PLATE/ASSEMBLY
(with LC option)
FIG.4
Hanger
Summary of Contents for HALV
Page 5: ......
