19724 MICROWAVE SENSOR FOR D10
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
TROUBLESHOOTING
If the sensor does not detect motion as expected:
• Check fixture mounting to compare fixture location and
sensor coverage with the coverage diagrams on pg 2
• Adjust fixture location as necessary
Fixture will not light/sensor does not detect motion:
• Make sure ON/OFF button was not selected as this
results in disabling the sensor
• Check all settings to be sure there is no conflicting
selection with the ambient light level
Fixture and sensor are too active:
• Check detection area setting and reduce coverage as
needed
• Increase time delay and/or adjust cut off period.
Basic Function Overview:
REMOTE CONTINUED
Detection Range Button Group:
assigns detection range of
10, 50 or 100%;
use coverage diagrams on pg 2 for guidance.
To limit area in which motion will set off sensor, use a smaller
percent. The sensor will not detect motion outside of 100%
and the fixture will not light.
Time Delay Button Group:
assigns hold time of 30 seconds,
1 minute, 5 minutes, 10 minutes, or 30 minutes
Cut Off Button Group:
assigns cut off period of 0 seconds,
10 seconds, 1 minute, 10 minutes, 30 minutes, or 1 hour. 0
seconds gives fixture on/off control rather than dimming.
+ ∞ keeps the light on always (if daylight sensor is disabled)
with Bi-Level dimming control.
Dim Level:
assigns level of 10, 20, or 30% for dimmed light
output after time delay passes
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation or maintenance.
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2016 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly sales@rabweb.com
19724 IN 0616
REMOTE
Sensor will beep one time
to indicate remote recieved
signal successfully
Remote settings will override
DIP Switch settings
ON/OFF:
disables sensor;
light is permanently* on or off
*un-do permanent on/off by
selecting either Auto-Mode, RESET,
or any Scene mode button
Auto Mode:
sensor activates
and all previously selected
settings remain programmed
RESET:
overrides selected
settings; reverts to DIP
settings
Dim buttons:
+ dims up and
- dims down, adjusting lamp
brightness
Black Button:
no function
Test 2s:
automatic* test mode with 2 second time delay;
disables cut off period and daylight sensor
*un-do automatic test mode by selecting either RESET, any Scene mode
button, or hold time
Power 100% & Power 80%:
adjusts power output; to save
energy select Power 80%. Must return to full output after initial
10,000 hours of LEDs by pressing Power 100%.
Group B:
Yellow Sun Button:
Ambient Daylight Threshold;
records surrounding lux level and overwrites previously
recorded value
.2, 1 and 5 fc:
sets daylight sensor at respective ambient light
values
Disable:
disables daylight sensor; any motion
registered by sensor activates fixture light
SC1, SC2, SC3, SC4:
assigns one of 4 pre-set scenes; see
“Operation” on pg 2 for scene descriptions
Fig. 5
100%
Re
du
ce
d L
ev
el
Occupied
Time Delay
Cut Off
G
roup B
Fig. 6
Summary of Contents for HALV
Page 5: ......
