20
05.2013
Albatros / Super-Albatros
Subject to technical modifications
Field work
The tractor lower links must allow for lateral motion
during work. However, when lifted they should be
locked as far as the tractor facilities allow for this.
Working depth
Set the desired ploughing depth with the hydraulic
systems in the field „draft load control“ or „mixed
control“. Set the constant working depth of all
plowing bodies at the top link - the plough frame
must lie parallel to the ground surface.
In case of „lower link control“ it might be useful to
attach the top link to the oblong hole at the plough
to ensure fast soil engagement at the start of the
furrow and to relieve the tractor three-point
hydraulics of load; for this allow some „tolerance“
for the top link pin at the front limit stop – better
control.
When the plough is equipped with a depth wheel
or combi wheel this is set on the ground only after
setting the depth - only depth monitoring.
Depth setting with spindle (
9/1
or
10/1
); depth
compensation from the left to the right side of the
plough may be done by turning the limit stop – cam
(
9/2
or
10/2
).
9
2
1
2
10
1
2
9
1
11
Inclination / Tilt
Each plough side is set separately. Ground surface
and plough leg should stand at a right angle (90°)
(see fig.
11
).
- Spindle
(8/1)
for right-handed plough side
- Spindle
(8/2)
for left-handed plough side
The tilt may also be used to compensate the depth
of the front plough bodies. If the first body at one
plough side is not working deep enough this should
be compensated by increased tilt towards the
ploughed soil.
8
2
1
Summary of Contents for Albatros Vari-HydroAvant
Page 2: ......
Page 4: ...4 05 2013 Albatros Super Albatros Subject to technical modifications...
Page 35: ......
