05/2003
9
1
2
3
11
Subject to technical modifications
Use
Operate the rotary harrow with 1000 series power
take-off.
Only switch the power take-off on and off if the
rotary blades are a few cm above the ground.
If the rotary harrow is to be lifted higher, switch off
the power take-off.
The rotary harrows and thus the gear unit input
shaft must be horizontal; make adjustments at
the top link (do not use the top link for the depth
adjustment!).
Adjust the working depth with pins
(9/1)
- all
equally; for this purpose, raise the rotary harrows
slightly.
Move the tractor
rear hydraulics to “floating
position”; the working depth is maintained at an
even level over the packer roller.
The control unit of the fold-in mechanism is in
“floating position” during work - for an improved
adaptation to the ground; however, if a greater
grading effect is desired, move the control unit to
“neutral” (cylinder fully extended).
Adjust the spring-mounted side panels
(9/2)
after
loosening the screws
(9/3)
corresponding to the
working depth - with a looser surface, bottom edge
max. 1 cm
in the ground.
Do not drive round tight corners when in use -
and raise the rotary harrows before “resetting”.
