KORMORAN PL V 180 / PL VHA 180
OPERATING
INSTRUCTIONS
- 42 -
9901.00.23EN00 - 01/2016
Adjustments
2
1
2
Key
1 Adjustment
screw
2 Counter
nut
ʈ
The front adjustment wheel can control side alignment on
its own. In this case, turn the adjustment screws (item 1)
below the turning cylinders. Position the screw heads and the
counter nuts (item 2) below the shaped supporting frame.
-
Unscrew the counter nut each time before adjusting the screw
length.
-
Re-tighten the counter nut each time after adjusting the screw
length.
IMPORTANT:
The inclination must be changed as soon as the
plough depth changes.
10.3.3
Adjusting the offset (width of the 1st track)
2SHQWKHRIIVHWVHWWLQJMLJWRLWVPD[LPXPSRVLWLRQ7KHIURQW
adjustment wheel must run in the track from the previous pass.
,WKHOSVWKHGULYHUZKHQVWHHULQJLQWKLVZD\WKH¿UVWSORXJKERG\
always ploughs to the same width as the other plough bodies.
The coupling responds in the optimum way if the centre of the
tractor is aligned with the centre of the plough.
IMPORTANT:
The offset setting jig must be folded in for turning
and for transport.
IMPORTANT:
If the 1st plough body picks up too much earth,
a furrow can occur. The mouldboard is not long
enough to cover the furrow again. Return the
mouldboard to a normal working position.
IMPORTANT:
For each pass on slopes, a width correction to the
1st track may be required to achieve an even furrow.
