specific codes), a message will be observed on the display.
11) If more than one DTC is found, use the
UP/DOWN
scroll
buttons, as necessary, until all the codes have been shown up.
4.2 Erasing Codes
CAUTION:
1.
Erasing the Diagnostic Trouble Codes may allow the scan
tool to delete not only the codes from the vehicle’s on-board
computer, but also “Freeze Frame” data and manufacturer
specific enhanced data. Further, the I/M Readiness Monitor
Status for all vehicle monitors is reset to Not Ready or Not
Complete status;
2. Do not erase the codes before the system has been checked
completely by a technician. Be remember, when you erase the
codes, please turn the ignition key to ON position, but NEVER
START THE ENGINE.
●
HOT KEY: Pressing and holding the ERASE button for at
least 3 seconds will allow you to quickly erase the DTCs
without going through the menu mode.
1
）
If you decide to erase the DTCs, use the
UP/DOWN
scroll
buttons to select
Erase Codes
from the
Vehicle Diagnosis
menu
and press the
Y
button.
21
●
If the scan tool is not connected or no communication is
established with the vehicle yet, then refer to Reading Codes
from 1 to 6 at Paragraph 4.1.
