Installation
Wall Inset Installation
I.
Produce hole in wall 310mm high by 145mm wide by 60mm deep.
2. Use size
8
or
l
0 screws with rawlplugs ( 4 oft) to fix back box int6 wall, with cut-out
at the bottom.
3. Connect the cabling, as detailed under "Electrical Connections", and then
fit
to the
back box (as described under Wall Flush Installation, item 3).
4. Use any suitable silicone waterproofing sealant (such as Unibond Waterproof
Flexibl.e Frame Sealant) to seal to the wall, leaving a 12mm to 13mm (0.5'') gap at
the bottom for drainage.
12-13mm (0.5'') gap
Wall Surface Installation
1. Fix the surface mounting back box to the wall,
with tut:out at the bottom,
size
8
or
l
0
screws with rawlp!Ugs ( 4 oft)
2. Connect the cabling, as detailed under "Electrical
Connections", and then fit to the back box (as
described under Wall Flush Installation, item 3).
3. Use any suitable silicone waterproofing sealant
(st.kh as Unibond Waterproof Flexible Frame
Sealant) to seal to the back box, leaving a 12mm to
13mm (0.5'') gap at the bottom for drainage.
- 7 -
4
off size
8
or 10 screws
at least 25mm (I") long
into Rawlplug type fixing:
