8
9
• Only use electrical sockets with grounding pins and secure residual current
circuit breakers (30mA).
• A maximum of one heater with two heating tubes (2 x 0.7kW) may be attached
to a 16A/B circuit breaker
• Turn on the heater by turning the switch to the “on” position (shown with a
line) and turn off the heater by turning the switch to the “ofF’ position (shown
with a circle). The tube will heat up completely within 10-15 seconds. You may
turn on either one of the heating tubes or both.
• The heater is hot while in use. To avoid burns, do not touch hot surfaces. Do
not touch the heater with wet hands. Always let the heater cool down before
relocating it to a new site.
• Do not move or lift the heater while it is in use. Always unplug the heater from
the power socket before handling it.
• Unplug the heater when it is not in use. Store the heater in a vertical position
with the power cable wound up to prevent damage. Regularly check the technical
condition of the product. When storing the heater far a longer period of time,
store it in its original packaging in a dry and well ventilated place.
• Replacement of heating tubes is handled by the manufacturer or authorised
service centre.
Warning
Some parts of this product can become very hot and cause burns. Special care
must be taken in the presence of children and the disabled.
The heater must not be used without a table top as there is a risk of injury due to
electric shock and burns.
