®
Portable Pit Stop Instructions
Assembly Cont.
fig. 7 - center tire
fig. 8 - check clearance
center tire
Place #2 so that your front tire will be centered. If your
vehicle has a wheelbase length longer than 90”, you will
notice a gap will be created. Fill this gap in with the #7
and #8 spacers, like shown. Use as many spacers as
required for your wheelbase length; it’s ok to have up to
0.5” of space between each spacer.
Now your PPS is fully assembled. Make sure that your car will not
scrape as it goes up the #1 Ramp section. If your vehicle won’t
clear the angle, we offer an optional extension. Please contact us
if you need this extension.
A spotter is HIGHLY RECOMMENDED for driving up the PPS
safely. Drive up the PPS at a slow, consistent speed.
DO NOT accelerate or brake violently.
Note: The wheel stop will NOT stop the car if you are going fast!
Drive slowly!
USE INCLUDED WHEEL CHOCKS (#10) to properly secure vehicle. Once your vehicle is
on the PPS, apply your emergency brake and leave the car in gear. Now you can remove all
the pieces except for #2 and #9, like shown. Remember, the #1 Ramps can be used inter-
changeably with the front and back of the PPS.
fig. 9 - use spotter