4
RaceAmerica Model 6632E Display Timer
PRODUCT OVERVIEW
The Model 6632E twenty-four inch digital
Display Timer is a micro-processor controlled
system based upon the 7-segment format display
digit using the latest technology Ultra-Bright
LEDs. The 6632E Display Timer is a standalone
integrated Timer and Digital Display with live
running time. Model 5140 Infra-red Track Sensors
located on the race track relay start and stop signals
to the 5432E for timing purposes. The system
operates on simple push-button operation for
Reset (Clear) and Sensor alignment or via optional
wireless control. Output can be captured with PC
Ccontrol software via a wireless transceiver.
RaceAmerica offers Display Timers in five,
eight, fifteen and twenty-four inch digits. The
display is viewable at wide angles and in full sun.
The Sensors operate in a wide range of conditions
from total darkness to full sun and are available
with operational ranges of 50’, 75’ and 150’. Time
connfiguration format and display brightness are
configurable.
A wireless option allows a PC to control the
timer and receive the data.
NOTE: THIS PRODUCT USES ULTRA-
BRIGHT LED TECHNOLOGY. DUE TO THE
BRIGHTNESS LEVEL OF THIS DISPLAY,
CARE SHOULD BE TAKEN, AS WITH ANY
BRIGHT LIGHTING SOURCE,TO AVOID
PROLONGED VIEWING AT CLOSE RANGE
AND SHORT DISTANCES. AS WITH ANY
BRIGHT LIGHTING SOURCE, VISION MAY
BE AFFECTED SHORT TERM SIMILAR TO
CAMERA FLASHES.
THEORY OF OPERATION
The Model 6632E Large Display Timer is a
standalone elapsed time (separate start and finish
points) timer and large digital display with an
interconnect cable to connect the Infra-red Sensors
and the hand-held push-button. The display timer
contains an alignment mode to insure alignment
of the sensors to the respective emitters at each
location on the track.
Pressing the push-button resets the display
and places the display timer into a ready mode.
When the vehicle passes between the start emitter
and start sensor ‘breaking’ the start beam, the timer
begins to count and displays the elapsed time in
four different formats from seconds and fractions
(ss.fff or sss.ff) to minutes/secons/fractions
(mm:SS.F) and hours/minutes (HR:MM-).
When the vehicle breaks the finish beam, the
timer displays the elapsed time in the configured
format. The timer is accurate to one thousandth
of a second.
The timer will not reset for a run if either of
the sensors are out of alignment.
PACKAGE COMPONENTS
1 - 15” digit Display Enclosure
2 - Hanger Plates
2 - 5140 Track Sensors
2 - 5040 Infra-red Beam Emitters
3 - Track cables - Start/Finish/Display sections
1 - Push-button cable
1 - Owner’s Manual
Model 6632E Available Options:
6501A 12VDC/3A AC Power Adapter
6401B Permanent Installation Kit (includes AC)
Emitter options:
50ft range - Model 5040 (standard)
75ft range - Model 5050
250ft range - Model 5060
‘W’ suffix - Domestic USA Internal Wireless
Datacomm link
‘X’ suffix - International Internal Wireless
Datacomm link
4520A Domestic Wireless Data Comm Links
4620A International Wireless Data Comm Links
Note: Wireless networks require a minimum
of two transceivers; one must be internal in a
display.
LOCAL REQUIREMENTS
Additional items required to operate the 6632E
Display Timer and options:
1 - 12VDC/2A Power source
1 - Mounting structure
