•
Time –
Configure internal clock using UTC time from internal GNSS monitor or set manually.
•
LAN
◦
DHCP
– Enable/Disable DHCP.
◦
IP Address
– Set the IP address assigned to LabSat 3.
◦
SUBNET MASK
- Set the Subnet mask assigned to LabSat 3.
◦
DEFAULT GATEWAY
- Set the default gateway for the network.
•
Digital*
◦
CH1
▪
1PPS –
Record 1PPS signal from internal GNSS monitor (disable power save).
▪
RS232 –
Record RS232 signal.
▪
CAN CH1 –
Record CAN Bus channel 1.
▪
DIGI –
Record state of DIGI input signal.
◦
CH2
▪
1PPS –
Record 1PPS signal from internal GNSS monitor (disable power save).
▪
RS232 –
Record RS232 signal.
▪
CAN CH2 –
Record CAN Bus channel 2.
▪
DIGI –
Record state of DIGI input signal.
•
CAN*
◦
Record Type
▪
Digitize –
When selected the CAN data will be digitized and integrated into the .LS3 file.
▪
Log File –
When selected the CAN data will be logged into a separate .txt file.
▪
CH1
▪
Baud rate –
Enables the user the set the desired baud rate.
▪
Silent Record
- Determines whether or not the LabSat sends an acknowledge pulse during
recording.
▪
CH2
▪
Baud rate –
Enables the user the set the desired baud rate.
▪
Silent Record
– Determines whether or not the LabSat sends an acknowledge pulse during
recording.
About –
Contains information specific to the LabSat e.g. serial number & firmware version.
Exit –
Return to file list.
*These are not included as standard in single constellation LabSat 3 units.
https://racelogic.support/03LabSat_GPS_Simulators/LabSat_3/LabSat_3_User_Manual/
15
Summary of Contents for LabSat 3
