Outputs: Digital Setup Menu (Channel 1 and 2)
OUTPUT
Press ’■’ and then use the ‘◄’ and ‘►’ buttons to
associate either of the following channels
SPEED
,
LAT
ACC
and
LONG ACC
to the
Digital output
. Press ’■’ to
confirm.
PULSES PER METER
This setting is only available when you have set the
output to
SPEED
.
Press ’■’ and use the ‘◄’ and ‘►’ buttons to set the
number of pulses per revolution. Press ’■’ to confirm
your selection.
Available range:
0.1 – 120
(in steps of 0.1)
MAX SPEED
This setting is only available when you have set the
output to
SPEED
.
Press ■’ and use the ‘◄’ and ‘►’ buttons to set the
maximum Speed. Press ’■’ to confirm your selection.
Available range:
0 – 400 km/h
(in steps of 1 km/h)
MAX VALUE
This setting is only available when you have set the
output to
LAT ACC
or
LONG ACC
.
Press ’■’ and use the ‘◄’ and ‘►’ buttons to set the
maximum value of that channel. Press ’■’ to confirm
your selection.
Available ranges:
0.5 – 2 g
(in steps of 0.1 g) for LAT ACC
0.5 – 2 g
(in steps of 0.1 g) for LONG ACC
MAX FREQUENCY
This setting is only available when you have set the
output to
LAT ACC
or
LONG ACC
.
Press ’■’ and use the ‘◄’ and ‘►’ buttons to set the
maximum Frequency you want to use on the digital
output. Press ’■’ to confirm.
Available range:
1 – 50 kHz
(in steps of 0.1 kHz)
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_II/VBOX_IISX_20_Hz_GPS_Data_Logger/
User_Guide%3A_VBOX_IISX_Data_Logger/03_Front_Panel_%E2%80%93_VBOX_IISX
12