•
If the USB connection is not supplying enough voltage to the unit, it will display a 'USB power may not
be adequate' message and will then restart once a button is pressed. However when restarted, you are
still able to
of the unit and perform
without NTRIP corrections.
Once power is applied to the unit, it will display VBOX and Racelogic logos along with the serial number and firmware
version of the unit.
If the unit is configured to use both the internal GSM modem and an external Wi-Fi hotspot, it will attempt to auto
connect to the Wi-Fi hotspot first on power up. Configuration of VBOX Sigma is performed using a Wi-Fi hotspot access
point created by the unit. You can then log in to this access point using your phone or a computer. A webpage is then
used to configure the unit to either use the internal GSM modem or an external Wi-Fi hotspot to connect to your chosen
correction service. Other settings options include CAN and VBO log settings along with status information. Settings are
retained after a power cycle, more information on this is
.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Sigma/VBOX_Sigma_User_Guide/03_-
_VBOX_Sigma_Getting_Started
19
