VB20SL User Guide
Page 11 of 30
Setup Antennas Menu (Pitch Antennas)
SEPARATION
LEVEL
SWAP
ANTENNAS
SLIP OFFSET
PITCH OFFSET
BACK
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to change the
antenna separation. Then press
’■’
to confirm.
Range is 0.0
– 5.0M in 0.1M
increments
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to enable or disable the
LEVEL option. With the LEVEL set
to YES the RTK lock is more
resilient.
But maximum ROLL or PITCH in
this mode should be 10 degrees.
Set to ‘ON’ to allow the
primary Antenna A to
be mounted ahead of
the Secondary
Antenna B.
Default is ‘OFF’. Then
press
’■’
to confirm.
Press
’■’
to enter the
Slip offset sub
menu. Within this
sub menu the Slip
offset can be
calculated and
applied or cleared.
Press
’■’
to enter the
Pitch offset sub menu.
Within this sub menu
a Pitch offset can be
calculated and applied
or cleared.
Press
’■’
to go
back to the Main
menu.
Smoothing Menu
Lat Acc
Long Acc
Slip
Pitch
Roll
BACK
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to
change the amount of
smoothing applied to the
calculated Lateral
Acceleration output. Then
press
’■’
to confirm.
0.0
–5.0 (0.1 steps)
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to
change the amount of
smoothing applied to the
calculated Longitudinal
Acceleration output. Then
press
’■’
to confirm.
0.0
–5.0 (0.1 steps)
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to
change the amount of
smoothing applied to the
Slip angle channel. Then
press
’■’
to confirm.
0.0
–5.0 (0.1 steps)
Press
’■’
and then use
the
‘◄’
and
‘►’
buttons
to change the amount of
smoothing applied to the
Pitch angle channel. Then
press
’■’
to confirm.
0.0
–5.0 (0.1 steps)
Press
’■’
and then use the
‘◄’
and
‘►’
buttons to
change the amount of
smoothing applied to the
Roll angle channel. Then
press
’■’
to confirm.
0.0
–5.0 (0.1 steps)
Press
’■’
to go back
to the Main menu.
