06 - VBOX Micro Connecting an Input module
The VBOX Micro can connect to any one of the following Racelogic input modules and then include the data from each
channel in the logged VBO file. The VBOX Micro will automatically log all channels from a connected Input Module
providing that the module is connected before the power is switched on.
Description
Part Numbers
Connection Cable
8 Channel Thermocouple Interface
RLVBTC8
RLCAB063
8 Channel (10 bit) Analogue
Interface
RLVBADC02
RLCAB063
8 Channel (16 bit) Analogue
Interface
RLVBADC03
RLCAB063
4 Channel Frequency and Pulse
Counter Input Module
RLVBFIM03
RLCAB063
Mini Input Module
RLVBMIM01
RLCAB063
Yaw Rate 2-Axis G
Sensor
RLVBYAW03
RLCAB065
Inertial Measurement Unit
RLVBIMU04
RLCAB065
Configuring the Input Modules
To configure an input module you must connect the module directly to the computer via a serial cable, the channels
cannot be setup via the USB port on the VBOX Micro. The software required will be VBOX Setup -
to check
which modules support VBOX Setup.
The module can take power from the VBOX Micro both during operation and during configuration.
https://racelogic.support//01VBOX_data_loggers/VBOX_Micro/VBOX_Micro_-_User_manual/06_-
_VBOX_Micro_Connecting_an_Input_module
18