The reference lap will be replaced with any subsequent
quicker lap time. However, you can fix a reference lap to
prevent faster lap times from replacing it.
Fix the reference lap time by pressing the
square
button
at any time during your lap. Pressing the
square
button
will either fix the lap you are currently driving or fix a lap
saved in the memory. You can choose which one your
LapTimer will use under
Fixed Lap Mode
in
the
Predictive Lap Timing Settings
Note: When you have fixed a reference lap, you will see
a message confirming your selection on the screen and
you will see a
padlock icon
in the top left corner.
•
If you fix a stored lap the icon will appear instantly.
•
If you fix the current lap, the icon will appear when
the lap you are currently driving has been
completed.
If you power-cycle the unit, clear the lap timing data or reset the start/finish, the fixed reference lap will be removed. If
you wish to retain a fixed reference lap, make sure that the lap is saved to the SD card. You can then load it into the
device when you need it.
If you
press and hold the square button
for 4 seconds
when in this mode, it will clear the stored reference lap
and clear all lap timing data.
Save Reference Lap
This feature allows you to save a reference lap for future use. Insert an SD card into the VBOX LapTimer and use
the menu options shown below. Note that the vehicle must be stationary to make this transfer. You can read more
about saving reference laps
https://en.racelogic.support//Product_Info/Lap_Timing_and_Pit_Timing/VBOX_LapTimer/
User_Guide_%E2%80%93_VBOX_LapTimer/04_Display_Modes_%E2%80%93_VBOX_LapTimer
17