Start / finish and split lines
Before the VBOXMini can measure and display times, you will need to either load previously recorded start / finish lines
or create new ones in your VBOXMini. This is done using either Simple Lap Timing, mentioned above, which sets only a
start / finish line or by setting a start / finish Line AND split points. In order to set a start / finish as well as split points,
follow the instructions below.
Setting start / finish lines
1. Press the
MENU
button to display the Lap Timing Menu.
2. Highlight ‘SET START & SPLITS’ and press
OK
3. As you drive across the start / finish line press
OK
4. This will set the start / finish line and the screen will now show the SET SPLIT1 screen.
5. To set the first Split, press
OK
when you pass this point or press
RESET
to skip.
6. If you wish just to place a separate Finish line, press the ‘
RESET’
button to skip all the split points and scroll to the
SET 2
nd
FINISH screen.
7. Press
OK
to set a separate finish line as you drive over it.
Note: you must be moving to be able to set virtual lines.
https://racelogic.support/01VBOX_Automotive/01VBOX_data_loggers/VBOX_Mini/
34
