Click
‘Save’
and save this firmware file to your desktop.
3.
Install the correct drivers.
Download and save our
. Extract and run the executable inside the folder.
Note: You may need to authorise a couple of windows security warnings.
4.
Connect Performance/ Drift Box unit to your PC.
Power up your PB/DB/VBM unit in
Upgrader mode
by holding the
mode
button down while applying power.
The unit will show ‘Upgrader’ and ‘Connect USB cable’ on the screen.
5.
Connect unit to your PC via USB cable.
The unit should change to show
‘Waiting to Connect’
.
You should also see a window appear in the corner of your PC screen saying
‘Your device is ready to use’
. You
are now ready to run the upgrade.
*If you see an error message, or a message telling you to restart your PC, just disconnect the PB/DB/VBM and
turn it off and then repeat steps 4 and 5. If you are still having problems, you may need to restart your PC.
6.
To run the upgrade, double click on the .RUF firmware file.
The upgrader software should appear. This will now automatically upgrade the firmware on your PB/DB/VBM unit.
7.
Reset GPS.
When you have successfully carried out the firmware upgrade, go outside and leave the unit with a clear view of
the sky. Select: MENU, SETUP then COLDSTART.
This will carry out a GPS cold start on the unit and allow it to search for satellites without using any stored previous
satellite locations.
https://racelogic.support/01VBOX_Automotive/01VBOX_data_loggers/VBOX_Mini/
53
