Speed units used are dependent on what is selected within the
area.
Decel Mode Overview
The Deceleration screen displays current/completed test information.
The screen is split in two halves:
•
Left hand side:
This includes a live speed display which always show the current speed of the vehicle,
irrespective of any test start or end conditions. If the vehicle is travelling less than 0.5 km/h or satellite lock is lost
(less than 4 sats), the value will display as 000.0.
•
Right hand side:
This contains test information dependent on which test is selected:
◦
Speed decel test
: Distance travelled, run number, time taken, average deceleration achieved, maximum
deceleration achieved (g) and height difference. These values will start to populate once the start condition of
the test is met. When the end condition is met, they will remain on screen until the start condition is met again.
A test can be reset by pressing the
button at the bottom of the screen.
◦
Trigger decel test
: Distance travelled, run number, trigger time, trigger speed, corrected distance,
MFDD and average deceleration. These values will start to populate once the minimum trigger speed is met
and the trigger is activated. When the vehicle is stationary (below 2.5 km/h), they will remain on screen until
the minimum trigger speed is met and the trigger is activated again. A test can be reset by pressing the
button at the bottom of the screen.
When the trigger is activated, '
ON
' will be displayed next to the Trigger test header.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_User_Guide/04_-
_VBOX_Touch_Display_Modes/VBOX_Touch_-_Decel_Mode
38
