Button
on the bottom left of the screen to return the Settings
screen without saving.
Note: If you press the Select button when you are not in
the vicinity of a known track, the unit will display a NO
LIST AVAILABLE message.
If the layout is changed, the LEDs will briefly flash
green
twice and the unit will emit an audible confirmation notification.
The layout will be remembered after each power cycle if it is determined to be local to the detected location.
Note: When the selected track is changed, all existing lap timing values will be cleared and the new lap timing gates will
be used.
Set Start/Finish Gate
Selecting the
Set Start Gate
option within the
manually set a start/finish line when moving,
overwriting the line detected within the circuit layout. If you are defining a separate
, this gate will act as the
Start Line only
. More information about manually setting a start/finish line can be found
Note: The vehicle must be moving >0.8 km/h and the unit have satellite lock to set a Start/Finish Line.
Set Finish Gate
Selecting the
Set Finish Gate
option within the
will manually set a Finish line when moving,
overwriting the finish line detected within the circuit layout. A separate finish line must be set if you are using
. More information about manually setting Finish line can be found
.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_User_Guide/04_-
_VBOX_Touch_Display_Modes/VBOX_Touch_-_Lap_Timing_Mode
61
