Note: If for some reason the SD card is removed while the unit is still recording, it may need to be repaired using a PC
before it can be reused.
Logging Switch
You can also control the logging by using an RLVBACS010 hand-held latching trigger switch (unlatched for logging/
latched for not logging).
Continuous Logging Mode
should be selected when using the switch. It is connected to the
3-pin
on the side of the VBOX Touch.
When the trigger switch is connected and latched, it is not possible to use the
SD Card Icon
to manually start or stop
logging data.
Logged Channels
VBOX Touch logs channels to an inserted SD card within a
file, channel information is available below:
•
Satellites
: This is the number of satellites in use.
•
Time
: This is UTC since midnight in the form HHMMSS.SS.
•
Latitude
: Latitude in minutes MMMM.MMve = North e.g. 3169.30644410M = 52D, 49M, 18.4S.
•
Longitude
: Longitude in minutes MMMMM.MMve = West e.g. 00040.18164742M = 00D, 40M, 10.9S.
•
Velocity:
Velocity in km/h.
•
Heading
: Heading in degrees concerning North.
•
Height
: Height above sea level in meters based on the model of the earth used by VBOX GNSS engines.
•
Vertical velocity
: Vertical velocity in km/h. +ve velocity uphill, -ve velocity downhill.
•
Long accel
: Longitudinal acceleration in g, +ve for forward acceleration.
•
Lat accel
: Lateral acceleration in g, +ve for acceleration to the left.
•
Solution type
: Indicator for what the unit is currently using to derive position: 0 = No sats; 1 = Standalone
using GNSS only; 2 = DGNSS; 3 = RTK Float (RTK but not full resolution); 4 = RTK Fixed.
•
Event 1 time
: This is the digital input oversample timer used to interpolate the trigger event time between captured
samples.
•
Correction age (VBOX Touch RTK only)
: RTK signal age in seconds, if there is a loss in connection, the value
resets at 60 s.
•
GPS Sats Used (VBOX Touch RTK only)
: Number of GPS satellites in use.
•
Glonass Sats Used (VBOX Touch RTK only)
: Number of Glonass satellites in use if selected within the
GNSS
Selection
area within the
General Settings
menu.
•
Beidou Sats Used (VBOX Touch RTK only)
: Number of Beidou satellites in use if selected within the
GNSS
Selection
area within the
General Settings
menu.
•
Galileo Sats Used (VBOX Touch RTK only)
: Number of Galileo satellites in use.
You can find more information about the VBO file format
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_RTK/
Quick_Start_Guides_%E2%80%93_VBOX_Touch_RTK/Quick_Start_guide_%E2%80%93_VBOX_Touch_RTK%3A__Speed_Mode
5
