LITHIUM BATTERY CHARGING
The left side of the first line shows the type of battery you choose.
The value on the left of the second line of the charger is current
user set, after setting the current and voltage, press
START/ENTER key for more than 3 seconds to start the process.
(charge current: 0.1-5.0A, voltage: 1-5V)
This displays the number of cells you set up and the processor
detects. “R” shows the number of cells detected by the charger and
“S” is the number of cells set by you at the previous screen. If both
numbers are identical you can start charging by press
START/ENTER button. If not, press BATT TYPE/STOP button to
go back to previous screen to carefully check the number of cells
of the battery pack before going ahead.
This screen shows the real-time status durning charge process.
Press BATT TYP/STOP key once to stop the charge process.
Lithium Balance Charging Mode
This function is for balancing the voltage of Lithium-polymer battery cells while charging. In
the balance mode, the battery needs to have a balance lead to connect to the individual port at
the right side of the charger. And you need to connect the battery’s output plug to the output of
charger. Charging in this mode is different from the normal modes, because the built-in proces-
sor monitors voltage of individual cell and control input current fed into each cell to normalize
the voltage.
LITHIUM BATTERY CHARGING
The value on the left side of the second lines sets the charge current.
The value on the right side of the second lines sets the
STAR/ENTER for more than 3 seconds to start the process.
This displays the number of cells you set up and the processor
detects. “R” shows the number of cells detected by the charger and
“S” is the number of cells set by you at the previous screen. If both
numbers are identical you can start charging by press
START/ENTER button. If not, press BATT TYPE/STOP button to
go back to previous screen to carefully check the number of cells of
the battery pack before going ahead.
This screen shows the real-time status during charge process. Press
BATT TYPE/STOP Key once to stop the charge process.
Individual Cell Connection Diagram (pin-assignment of 8-pin) Balance Diagram
18
19
