DATA STORAGE PROGRAM
For your convenience the SC2000 has a data storage and load program. It can store five battery
data representing the respective specifications of batteries. You can call back the data when
charging or discharging without setting up the program again. Press START/ENTER key to
make it blink, and use INC or DEC to set up the parameter.
Setting of the parameter in the screen will not affect the charge and dis
charge process. They just present the specification of the battery. The
example is NiMH battery pack, including 12 cells, the capacity is 3000m
Ah.
Set up the charge current in the manual mode, or current limit in the auto
mode. Press INC and DEC key simultaneously to make the current field
blink to switch the charge mode.
Set up the discharge current and final voltage.
Set up the charge/discharge sequence and cycle number.
Saving the data.
LOAD DATA PROGRAM
This program is to load the data stored at the “save data” program. Press START/ENTER key to
make the data field blink and press INC or DEC for more than 3 seconds to load the data.
Choose the data number you want to call back. The data you want to
call back will be displayed.
Loading the data.
Programming Information
You can inquire various information on the LCD screen during the charging and discharging pro-
cess. Press DEC key, the charger will display users’ setting. You can press INC key to monitor
voltage of each cell while the battery is connected with each port of the charger.
26
27
